Page 6
Your product has been engineered and manufactured to cleaning, maintenance or storage. Ryobi’s high standard for dependability, ease of operation, ■ Inspect the unit before each use for loose fasteners, and operator safety. Properly cared for, it will give you fuel leaks, etc.
Page 7
English(Original instructions) installing the blade. to possibly reduce the effects of vibration: ■ Do not attempt to touch or stop the blade when it is a. Keep your body warm in cold weather. When operating rotating. the unit wear gloves to keep the hands and wrists ■...
Page 8
English(Original instructions) Wear non-slip safety footwear when Guaranteed sound power level is 113 dB. using this equipment. Choke closed Wear non-slip, heavy duty gloves. Choke open. Use unleaded petrol intended for motor vehicle use with an octane rating of 91 [(R + M)/2] or higher.
Page 9
English(Original instructions) 42. Choke lever NOTE: The blade guard should remain fitted to the 43. Blade cover product at all times. 44. Air fi lter knob Grass defl ector 45. Air fi lter cover 46. Filter See fi gure 6. 47.
Page 10
English(Original instructions) 6. Install the hex bolt to secure the string trimmer head Installing the blade to the drive shaft. Tighten by using the hex-shaped See fi gure 7. opening on the inside of the bump knob. 1. Place the upper fl ange washer over the gear shaft with NOTE: Only use the bump knob to tighten the bolt.
Page 11
English(Original instructions) ■ Use the tip of the string to do the cutting; do not force the string head into the uncut grass. ■ Wire and picket fences cause extra string wear, even 1 Litre 33 ml breakage. Stone and brick walls, kerbs and wood may 2 Litres 67 ml wear string rapidly.
Page 12
English(Original instructions) the kick-back reaction of the cutting blade. MAINTENANCE ■ Adjust the strap hanger to a comfortable position. WARNING Exercise extreme caution when using the blade with the product. Blade thrust is the reaction that may occur when Use only genuine replacement parts and accessories. the spinning blade contacts anything it cannot cut.
Page 13
English(Original instructions) a thrown object as the blade begins to turn. ■ Drain all of the fuel from the tank into a container approved for gasoline. CLEANING THE EXHAUST PORT AND SILENCER ■ Run the engine until it stops. Depending on the type of fuel used, the type and amount ■...
Page 14
English(Original instructions) TROUBLESHOOTING Problem Possible cause Solution The spark plug may be damaged, remove it and check for No spark dirt and cracks. Replace with a new spark plug. Push primer bulb until bulb is full of fuel. If bulb does not fi...
Need help?
Do you have a question about the RBC52FSB and is the answer not in the manual?
Questions and answers