MSI P35 Neo series User Manual page 48

M S-7360 M ainboard
Re-Call VGA BIOS From S3
W hen ACPI Standby State is set to [S3], users can select the options in this field.
Selecting [Enabled] allows BIOS to call VGABIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an VGA driver to initialize
the VGA card. Therefore, if the VGA driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Suspend Time Out (M inute)
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off.
Power Button Function
This feature sets the function of the power button. Settings are:
[Power Off]
[Suspend]
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Off]
[On]
[Last State]
Wakeup Event Setup
Press <Enter> and the following sub-menu appears.
Resume From S3 By USB Device
The item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state.
Resume From S3 by PS/2 Keybo
This setting determines whether the system will be awakened from what power
saving modes when input signal of the PS/2 keyboard is detected.
3-14
The power button functions as normal power off button.
W hen you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Always leaves the computer in the power off state.
Always leaves the computer in the power on state.
Restores the system to the status before power failure
or interrupt occurred.