Display Subcomponents (Bezel, Webcamera, Panel) - HP ENVY 14 Maintenance And Service Manual

Display subcomponents (bezel, webcamera, panel)

This section describes removing display subcomponents that do not require that you remove the
entire display assembly from the computer. You can remove the display bezel, webcam/microphone
module, and display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, you must remove the entire display assembly from
the computer. See
assembly in its entirety.
Description
Display bezel (includes screws)
Raw display panel, 14 in (35.56 cm), WLED, HD, BrightView flat display panel
Raw display panel, 14.0 in (35.56 cm), FHD, WLED, SVA Antiglare slim display panel
Webcamera/microphone module
IMPORTANT:
and replacement
Before removing the display panel, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Remove the panel:
If it is necessary to replace the display bezel:
1. Remove the plastic screw covers (1) and the two Phillips M2.5×3.0 screws (2) that secure
the display bezel to the display assembly.
2. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Flex the inside edges of the top edge (3), the left and right sides (4), and the bottom edge
(5) of the display bezel until the bezel disengages from the display enclosure.
Display assembly on page 61
Make special note of each screw and screw lock size and location during removal
Battery on page
for more information about removing the display
29).
Component replacement procedures
Spare part number
767365-001
763566-001
767373-001
762521-001
33