Locations For The Control Module - Viper 7900 Installation Manual

locations for the control module

Some things to remember about where to mount the control module:
■ Never put the control module in the engine compartment!
■ The first step in hot-wiring a vehicle is removing the driver's side under-dash panel to access the
starter and ignition wires. If the control module is placed just behind the driver's side dash it can easily
be disconnected.
■ When mounting the control module, try to find a secure location that will not require you to extend the
harnesses' wires (they are 1.5 meters long). Keep it away from the heater core (or any other heat sources)
and any obvious leaks.
■ Some good control module locations are: Above the glove box, inside the center console, above the
under-dash fuse box, or above the radio.
mounting the antenna
The antenna position should be discussed with the vehicle's owner prior to installation, since the antenna
may be visible to the vehicle's operator. The best location for the antenna is centered high on either the
front or rear windshield. For optimal range, the antenna should be mounted horizontally. It can be mounted