Attaching The Main Wing; Installing The Flight Pack Into The Fuselage - MegaTech Sky Vector Quick Manual

gone through 3 or 4 charge and discharge cycles. After that, you should be attaining
full flight duration times.
NEVER LEAVE A CHARGING BATTERY UNATTENDED!! Always let the flight pack
cool before recharging.
• Connect the battery to the wall charger.
• Note: Only use a charger that is approved for use with this battery
• Plug the charger into an electrical outlet
• Children must have parental supervision during the charging process
• Charge the battery for 1-2 hours.
• Always monitor the charging process. The flight pack should become good and
warm but do not let it become extremely hot! DO NOT OVERCHARGE THE
BATTERY. Use extra caution when touching the battery because it may become
very hot.

4. Attaching the Main Wing

• Place the main wing onto the fuselage with the polyhedral design curving upwards
and wingtips pointing towards the v-tail.
• Make sure the small arrows imprinted into the wing are centered over the fuselage
• Wrap the Wing Bands around the fuselage and the wing in an "X" pattern and then
a "II" pattern as shown
Wing Band Placement

5. Installing the Flight Pack into the Fuselage

• Open the battery hatch on the front of the Sky Vector
fuselage
• Make sure to leave all foam pieces inside the fuselage,
this ensures proper placement of the flight pack
• Place battery into fuselage with the wide section of the
battery towards the front as shown
• Attach the battery connector with the connector inside
the fuselage
• Close battery hatch cover when done
Center Wing on Fuselage
Flight Pack Placement