Table of Contents
Advertisement
DOG DRIVE (Every Day) - VERY IMPORTANT
Apply a small squirt of lubricating oil (2-3 drops) directly into each hole in the top of the
drive shaft cover. This keeps the clutch slippers lubricated.
CONTROL LEVERS AND CABLES (Every 2 Months)
To keep the controls free from rust and corrosion apply a small charge of oil to the
throttle and clutch control levers every two months. Oil fl ow can be assisted by working
the levers open and closed a few times after the lubrication is applied.
FRONT ROLLER ADJUSTERS (Every 2 Months)
Apply a small quantity of copper grease or similar to the adjuster studs to prevent corrosion and ease adjustment.
The machine should always be kept in a clean dry place, free from condensation. After use ensure that the machine is
thoroughly clean, dry and free from grass and mud. Before off season storage smear a thin layer of grease on to the
cutter blades and the shear blade.
Under no circumstances must the machine be steam cleaned as this may remove grease from the pre packed bearings.
Because of the nature of lead free petrol we recomend that if the machine is being left unused for more than 2 weeks the
carburetor is run dry. Allow the engine to run out of fuel with the fuel tap switched off.
NOTE
This manual contains listing of parts for the Dennis FT430, FT510 and FT610 machines. An illustration of the parts as an
assembly is shown above the list.
Where parts are given a description of LH or RH (left hand or right hand) this is as viewed from the users position.
The Parts Listings for FT Range can be found in this manual from page 18 onwards.
FT Range
WHEN ORDERING PARTS PLEASE QUOTE YOUR MACHINE SERIAL NUMBER AND
ENGINE NUMBER. A BOX TO ENTER THESE FOR EASY REFERENCE IS AT THE
BEGINNING OF THE MANUAL.
Guide To Replacement Parts
16
General Lubrication
Lubricate
Daily
Storage
SP20001_REV_2
Hide quick links:
Advertisement
Table of Contents
