Avital 4100 Installation Manual page 27

C C H H A A N N N N E E L L N N U U M M B B E E R R
1
2
3
4
5
6
7
8
* * N N O O T T E E : : For Auto Learn Configurations, see Transmitter Configurations section of this
guide.
* * * * N N O O T T E E : : If any button from a known transmitter is programmed to Channel 8, all
transmitters will be erased from memory and will revert to the default feature set-
tings. This is useful in cases where the customer's transmitters are lost or stolen.
T T r r a a n n s s m m i i t t . . While H H O O L L D D I I N N G G the
3.
would like to control the selected receiver channel.
4. R R e e l l e e a a s s e e . . Once the code is learned, the Program switch can be released.
You can advance from programming one channel to another by releasing the Program switch and tapping it to
advance steps and then holding it. For instance: You have programmed Channel One and you want to program
Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to
Channel Two. Now, press and H H O O L L D D the Program switch. The LED will flash two times. As before, do not release
it.
If you want to program Channel Three after programming Channel One, release the Program switch, press it twice
and release it to advance to Channel Three. Then press it once more and H H O O L L D D it. The LED will flash three times
to confirm it is ready to receive the code from the transmitter.
L L e e a a r r n n R R o o u u t t i i n n e e w w i i l l l l b b e e e e x x i i t t e e d d i i f f : :
■ Ignition is turned off.
■ Program switch is pressed too many times.
■ More than 25 seconds elapses between programming steps.
© 2005 Directed Electronics—all rights reserved
F F U U N N C C T T I I O O N N
Auto-Learn*
Lock/Unlock
Channel 2 output
Remote Start
Turbo/Short Run
Timer Mode
Defogger Control
Delete all Transmitters**
, press the button on the transmitter that you
Program switch
2 2 7 7