Chapter 2. Setting up the projector
This chapter provides information on starting and shutting down the projector,
adjusting the projector height and level, adjusting the zoom, focus, and keystone,
and adjusting the volume.
Attention: Before moving the projector, be sure to power down the projector
normally and disconnect the projector from the main power source.
Starting and shutting down the projector
Please follow the steps below to start the projector and to shut down the projector.
1. Connect the power cord to the projector as shown below. Connect the other
2. Remove the lens cover.
3. Connect to an input device.
4. Turn on the connected devices.
5. Ensure that the Lamp-ready LED is on a steady amber, then press the Power
6. If more than one input devices is connected, press the Source button repeatedly
7. To turn off the projector, press the Power button. The projector prepares for
© Copyright IBM Corp. 2004
end to a wall outlet. The Power LED and Lamp-ready LED turn on.
button to turn on the projector.
The projector splash screen displays and connected devices are detected. If the
connected device is an IBM ThinkPad, press Fn + F7 on the computer keyboard
to switch the display output to the projector. Check the user's manual of
non-IBM PCs to determine the appropriate Fn hot keys to change display
output.
Attention: Do not look directly into the projection lens when the lamp is
turned on. The bright light may harm your eyes.
to switch among devices.
shutdown, and a "Wait a moment please..." message appears.
2-1