Subscribe to Our Youtube Channel
Related Manuals for Omega Altise OPM15E
Summary of Contents for Omega Altise OPM15E
- Page 1 OPM15E, OPM20E & OPM24E Micathermic Panel Heaters Electronic & Remote Control Instruction Manual...
-
Page 2: Important Safety Instructions
Important Safety Instructions 1. Disconnect the power plug before dismantling, assembling or before cleaning. 2. Make sure the heater is on a dry and even surface. 3. Always use the heater in an upright position. 4. Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock, fire or damage to the appliance. -
Page 3: Specifications
Specifications Model OPM15E OPM20E OPM24E Rated Voltage 240V / 50Hz 240V / 50Hz 240V / 50Hz Watts 1500W 2000W 2400W Controls Electronic & Remote Electronic & Remote Electronic & Remote Thermostat Heating Element Micathermic Micathermic Micathermic 3 settings:... - Page 4 TO WALL MOUNT THE PANEL Where to install the heater? 1. Ensure the safety zones (mm) in following figure are kept free (see Figure 1). 2. The panel convector must not be installed immediately below a wall socket. The heater must be connected to a socket outlet or Figure 1.
- Page 5 1. Using the wall mounting bracket as a template for positioning, place the bracket against the wall with the hole approx 1m above the floor. Mark the screw-hole through the hole in the bracket. 2. Drill the first hole as marked.
-
Page 6: Switching On The Unit
Operating Instructions Before connecting this product to the power supply: 1. Be sure to place the convection heater on a flat surface. 2. Set the temperature control to low. 3. Set the power switch to off. Switching on the Unit The unit may be switched on (setting I) or off (setting O) by using the switch (2) on the right side panel. -
Page 7: Remote Control
ON / OFF Timer Timer ON 1. Press the SET button twice. The time display will flash along with the word ON (left of the time display). 2. While the time display is flashing press the UP and DOWN buttons to reach the time in hours until you want the unit to start. -
Page 8: Safety Features
5. SET THE TIMER ON: Press the SET button twice. The time display and the word ON will flash. While the time display is flashing press the “ ” “ ” buttons to reach the time until you want the unit to start. The “ ” button adds 1 hour per press, the “... -
Page 9: Care And Maintenance
Care and Maintenance 1. Always disconnect the cord from the electrical outlet when cleaning your heater. 2. Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner using the dusting brush attachment.
Need help?
Do you have a question about the OPM15E and is the answer not in the manual?
Questions and answers