Failure to comply with instructions could result in personal injury and/or property damage. If you are unsure about anything regarding your heater or these instructions, please contact Omega Altise on 1300 795 572 in Australia or (09) 415 6000 in New Zealand before operating your appliance Read all instructions carefully before using the panel convection heater.
Allow the room to heat up to the desired temperature. c) Adjust the control knob anti-clockwise until the indicator(s) turn off. d) Adjust the control knob clockwise until the indicator(s) turn back on & leave it there. OMEGA ALTISE...
(do not over tighten). Note: The heater gets hot when in use, so it is best not to move when in use. If it must be moved, use the plastic side panels. OMEGA ALTISE...
Page 6
Check that they are fixed correctly. If possible, have a second person help to check for alignment as the heater is attached. The heater is now ready to connect to the mains power. Omega Altise recommend wall mounting only to brick walls. OMEGA ALTISE...
Page 7
It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Omega Altise reserves the right to alter specifications or appearances without notice.
Page 8
A division of Shriro Australia Pty Ltd 104 Vanessa St Kingsgrove NSW 2208 In Australia: 1300 795 572 In New Zealand: (09) 415 6000 www.omegaaltise.com IM Ref: OCON203B 19/2014/11 OMEGA ALTISE...
Need help?
Do you have a question about the OCON203B and is the answer not in the manual?
Questions and answers