Drill Master 91396 Set Up And Operating Instructions Manual page 10

6. While charging, the Battery (11A), Battery Charger (24A), and AC/DC Adapter
(25A) may become warm to the touch. This is normal, and does not indicate a
problem. (see figure d.)
7. Once the Battery (11A) is fully charged, disconnect the Battery Charger (24A)
2-Prong Plug from the electrical outlet. Next, disconnect the AC/DC Adapter
(25A) Cord from the Battery Charger. Then, remove the Battery (11A) from the
Battery Charger. (see figure d.)
to operate the drill:
Warning! Always make sure the Trigger (18A) of the Cordless Drill is in its "off"
position, the Battery (11A) is removed from the Drill, and the Battery Charger
(24A) is unplugged from its electrical outlet prior to making any adjustments to
the tool. (see figure e.)
chuck
(5a)
rotation Button
1. the chuck (5a): Accepts up to 3/8" diameter Drill Bits, Driver Bits, and a Hex
Driver Extension. To install a Drill/Driver Bit or Driver Extension, hold the Chuck
Sleeve firmly in place and turn the Chuck counterclockwise. Insert the shank of
a Drill/Driver Bit or Driver Extension all the way into the Chuck. While holding
the Chuck Sleeve in place, turn the Chuck clockwise to lock the Drill/Driver Bit or
Extension in place. (see figure e.)
SKU 91396 for technical questions, please call 1-800-444-3353.
torQue setting ring
(26a)
chuck
sleeve
(13a)
trigger
(18a)
figure e
BatterY
(11a)
Page 10