Installation Guide; Before Starting; Package Content; Cautions On Installation - Clarion NX702A Quick Start Manual & Installation Manual

Installation Guide

Before Starting

Car battery

Package Content

Source unit ................................................1
Wiring harness...........................................1
GPS antenna .............................................1
CLAMP for cable of GPS antenna and
digital TV antenna......................................9
DOUBLE FACE TAPE for GPS Antenna...1
Remote control unit ...................................1
Battery (CR2025).......................................1
(Installed in remote control)
2Din Trim ring (wide) .................................1
2Din Trim ring (narrow) ..............................1
Cleaning cloth ............................................1
Quick Start Guide ......................................1

Cautions On Installation

1. Prepare all articles necessary for installing
the main unit before starting.
2. Install the unit within 30° of the horizontal
plane.
3. If you have to do any modification on the
car body, such as drilling holes, consult
your car dealer beforehand.
4. Use the included screws for installation.
Using other screws can cause damage.
5. This unit has a fan motor in the back
of the main unit so as not to raise the
temperature in the source unit. When
the fan motor vent is covered with cords
or mounting bracket, it may cause a
malfunction. Be sure not to cover it when
wiring cords.
1. This set is exclusively for use in cars with a
negative ground, 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery " " terminal
before starting. This is to prevent short circuits
during installation.
Owner's manual (CD-R) ............................1
Electro tap .................................................2
Flush mount bolts(M5x6) ...........................8
Hexagon Head Screw(M5x6) ....................8
Line out cable ............................................1
Rear Zone out cable ..................................1
SWC cable.................................................1
External Microphone cable ........................1
Camera Visual IN AUX cable ....................1
USB cable..................................................1
Digital TV Antenna.....................................2
Max. 30°
Chassis
Damage
Max. 6 mm (M5 screw)
Fan motor vent
Installation Guide

Installing The Main Unit

This unit is designed for fixed installation in the dashboard.
1. When installing the main unit in NISSAN vehicles, use the parts attached to the unit (see "
NISSAN"). When installing the main unit in TOYOTA vehicles, use the parts attached to the
vehicle (see " TOYOTA").
2. Wire as shown in "Wire Connection".
3. Reassemble and secure the unit in the dashboard and set the face panel and center panel.
Mounting Screw Holes (Side View of the Main Unit)
NISSAN
NISSAN
6-Spacer (thickness: 1 mm)
Mounting bracket
(1 pair for the left and right sides)
TOYOTA
Center Panel *1
*2
Screws marked and mounting bracket are attached to the vehicle.
TOYOTA
6-Flat head screw (M5 × 6)
(attached to the main unit)
8-Hexagonal screw (M5 × 6)
Mounting bracket
(1 pair for the left and right sides)
NX702A 9