Clarion NX702A Quick Start Manual & Installation Manual page 12

Dvd multimedia station with built-in navigation & 7” touch panel contro
Table of Contents

Advertisement

Installation Guide
Gray
Front Right /MID-R
Gray/Black
White
Front Left /MID-L
White/Black
Purple
Rear Right /HIGH-R
Purple/Black
Green
Rear Left /HIGH-L
Green/Black
4-Speaker system
or
2-Speaker system
Gray
Front Right
Gray/Black
White
Front Left
White/Black
Purple
Purple/Black
Green
Not used.
Green/Black
Insulate each wire
12
NX702A
18-Pin Connector Extension Lead
(attached to the source unit)
Brown wire (Phone mute lead)
Connect to cellular phone mute lead.
Yellow wire (Memory back-up lead)
Connect directly to battery
Red wire (Power lead)
Accessory
12V
Blue/White wire (Amplifier turn-on lead)
Connect to remote turn-on lead of amplifier
Black wire (Ground lead)
Connect to vehicle chassis ground
Orange/White wire (Illumination lead)
Connect it to the car power supply terminal
for illumination
Blue wire (Auto antenna lead)
Connect it to the car power supply terminal
for antenna
Fresh Green wire (Parking)
Connect it to the car power supply terminal
for parking
Purple/White wire (Reverse)
Connect it to the car power supply terminal
for reverse
Installation Guide
Note:
*1 C onnect to the AUX audio input terminal and the iPod video input terminal. (Audio connection
is required only when [Analog] is selected for the iPod output signal. See Owner's Manual.)
*2 I n certain vehicles - Volkswagen/Opel/Vauxhall - it is necessary to exchange the accessory
<<Red>> and the main power <<Yellow>> connection, to avoid overload and loss of memory.
*3 W hen the unit is installed in a 1998 or later Volkswagen model, make sure to interrupt the
<<Remote>> output.
D isconnect the <<blue/white>> wire and insulate the front ends of this cord. A breakdown may
occur if the cord is not disconnected, or front ends are not insulated.
Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
• C onnecting the parking brake cord to lamp ground allows you to watch video images when
the parking brake is engaged.
• W hen the parking brake cord is not connected, the monitor will not display video images.
Parking brake lamp
cord to battery
Electro-tap
Parking brake signal cord
Parking brake cord (Grass-green)
Parking brake signal cord
Stopper
Parking brake cord (Grass-green)
Parking brake

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents