Connections - Ecleree IC SERIES Instruction Manual

IC6
•
2 way speaker for false ceilings
•
6.5" polypropylene woofer
•
25mm tweeter
•
Power: 40W RMS@8Ω
•
Sensitivity (1W/1m): 90 dB SPL
•
Built-in 100V transformer. Power selector: 2.5/5/7.5/15W
•
External diameter: 204mm
•
Cut out diameter: 180mm
•
Installation system: Three revolving fasteners
IC8
•
2 way speaker for false ceilings
•
8" polypropylene woofer
•
25mm tweeter
•
Power: 60W RMS@8Ω
•
Sensitivity (1W/1m): 91 dB SPL
•
Built-in 100V transformer. Power selector: 5/7.5/15/30W
•
External diameter: 245mm
•
Cut out diameter: 222mm
•
Installation system: Three revolving fasteners
Note: If you use the speaker for false ceiling in 70V installations, the power for the 100V position will
be half the amount shown on the switch. When used in 50V installations, it will be a fourth of the
amount.
Each model in the series comes with a protective grill that can be removed with a hook
included in the package. Be careful not to damage the speaker when removing the grill.

4. CONNECTIONS

The connection terminals for each
model are clamps for stripped wires. Once
they are connected, all you have to do is
choose the unit's power and mode of
operation using
Always pay attention to the polarity.
The IC series are shipped from factory with the switch in 100V position. If it is
connected to a low-impedance amplifier, the speaker will not be damaged, but will perform
way below its full potential. If the speaker is accidentally connected to a 100V line in the 8Ω
position, it will be severely damaged.
Use the three revolving fasteners included to easily install the units. For more information
on how to install the units, please see section 5 of this manual.
a simple screwdriver.
5