Advertisement
Quick Links
Advertisement
Related Manuals for LENCO DF-831
Summary of Contents for LENCO DF-831
- Page 1 DF-831 8” Digital photo frame User manual For information and support, www.lenco.eu...
- Page 2 1. Getting started: Checking the appearance: Sensor for remote control 2. Understanding interface and on-board buttons: (1). Menu B ack; ／ On/Off (7) . Confirm (2) . . mini USB port ⑻ (3) . Down; (9). USB port; (4) . Up; (10).
- Page 3 3. Installing and recharging your unit: Open the package and remove the protective sleeve from the unit. Screw in the stand to the stand screw hole on the back of the photo frame, Adjust the frame position for vertical or horizontal placement, Plug in the AC adapter into power outlet. Plug the other end into the unit.
- Page 4 2. Playing photos Figure 2 Figure 3 You can slideshow the photos one by one(Figure 2), or display in thumbnail mode(Figure 3) 3. Select the media source Figure 4 Figure 5 Select “Device” to show the media source, there are 3 media sources including internal memory, SD card and USB drive (Figure 5).
- Page 5 5. System setup To enable some customized features, please configure the frame via system setup as below: a. Photo Setup Figure 8 Under “Photo Setup”, you can configure Display model, Display Ratio, Slideshow Interval, slideshow repeat as well as transition effect. Navigate with Left / Right button to change the options, use Up/Down to switch between menus.
- Page 6 b. Calendar Setup Figure 9 As shown in Figure 9, you can configure Display mode(Analog Colck, Digital Clock), set the right date, Change the clock mode from 24hr to 12hr or vice versa, change the current time settings. Navigate with Left / Right button to change the options, use Up/Down to increase/decrease the numbers.
- Page 7 Figure 10 Figure 11 (1). Language As show in Figure 10, select language menu, you can change the language with left/right buttons. (2). Auto power On/Off To enable power on/off, firstly, please select “On” to enable power On/ Power Off, as shown respectively in Figure 10 &...
-
Page 8: Troubleshooting
Trouble-shooting: Symptom Cause Corrective Actions Digital Picture Frame The POWER connector to Make sure you connect the AC doesn’t power on the unit is not securely adapter to the frame properly and inserted. make sure you have powered on the unit by using the On/Off button.