Table of Contents
Advertisement
Switch functionality
Pump
Turbine
IMPORTANT: Correct cleaning of this sprayer is essential for successful operation on next use. Please
refer to the How to DVD and the cleaning section of your operational manual on how to clean your
sprayer.
The Gemini can be set up for two different applications, spraying directly
from the paint tin or Gemini Bucket for large projects or from the Paint
Pot for small projects.
Fig.8
Fig.9
Fig.10
Paint speed dial
Paint flow adjuster
Large Projects
Direct from the paint tin (or Gemini Bucket)
(water-based coatings only)
Product - Set Up & Assembly
Additional items required before you start: • Drill • Cloth
Spraying direct from the paint tin:
1) The head unit is secured with two container catches. Gently pull outwards on these to dislodge
the catches, and remove the head unit.
2) Unscrew the Paint Pot (12) (Fig.8) and remove the Rigid Pick-Up Tube (11) from the spray gun
(Fig.8) and then insert the bare end of the 4m paint tube through the Spray Gun Connecter
Assembly (10) and fit it over the inlet (this is the one with the smaller aperture on underside of the
gun) (Fig.9).
Tip: Tube can be softened by running under hot water.
3) Ensuring that it is correctly aligned, screw the Spray Gun Connecter Assembly (10) onto the gun
>>
- pushing as you twist.
4) Fit the the 4m Paint Tube (13) to the Paint Outlet (14) (Fig.10) on the motor unit - using the quick
connect fitting. Give a gentle tug on the paint tube to ensure that it is secure.
5) Set the Paint Flow Adjuster (8) on the gun to maximum by scrolling upwards (Fig.10) and then
firmly push/ clip the gun into the docking station on the motor unit until you hear a 'click' (the
trigger should be depressed sitting in the docking station).
6) DO NOT FIT the Air Hose (15) to motor outlet and gun at this stage yet.
8
HORIZONTAL
ROUND
VERTICAL
DVD
Advertisement
Table of Contents
