Page 1
TOLL FREE: 888-783-2612 NO DEVUELVA EL PRODUCTO AL ESTABLECIMIENTO SI HA SIDO USADO. En caso de dudas y preguntas relacionado con el producto contacte con el servicio Earlex llamando al TELÉFONO GRATUITO 888-783-2612 NE PAS RETOURNEZ LE PRODUIT AU MAGASIN SI CE DERNIER A DÉJÀ...
Page 2
IMPORTANT INFORMATION Certain coatings may require dilution. INFORMACIóN IMPORTANTE Ciertas capas requieren disolución. IMPORTANT Certains revêtements doivent être dilués. (not supplied) (no suministrado) (non fourni)
Page 3
® call our customer service number (593) 22530912 ext.12. Alternatively visit our website at www.earlex.com or www.pintulac.com.ec. DO NOT PUT PAINT INTO THE UNIT if the unit does not function in the event you have to return the product due to a malfunction then the store will not take the SprayStation Gemini back.
SAFETy INSTRUCTIONS WARNING! FIRE AND EXPLOSION HAZARD DO NOT USE SOLVENTS IN THE GEMINI BUCKET OR WHEN SPRAyING DIRECT FROM THE • CAUTION! TO REDUCE THE RISK OF • You must clean the spray gun thoroughly after ELECTRIC SHOCK OR INJURy, DO NOT each use.
Page 7
Spraying directly from the paint can or Gemini Bucket; Suitable Not Suitable Water-soluble interior and exterior paints, water-based wood Solvent-soluble coatings, 2-pack paints, highly abrasive and textured coatings as well as coatings WITH A FLASH POINT treatments and water-based varnishes.
3) To achieve a round application set Spray Direction Plate (4) (as shown). Spraying with your SprayStation Gemini® is very intuitive and through a little practice you will very quickly become a good sprayer. When practicing adjust the Paint Flow Adjuster (8) and spray patterns to see the effect this has (Fig.4).
Page 9
>>paint (paint can either be poured directly into the bucket or preferably you can use the paint can >>that it comes in). 6) Ensure the paint can is placed under the gun – use the rings on the base of the Gemini Bucket >>(25) as a guide.
Page 10
8) When the paint starts to comes through the tip of the gun your unit is primed (this should take up to 2min). Turn pump off. 9) Uncoil the black Air Hose (15) from around the Gemini Bucket (25), and fit to the head unit and >>>gun using a TWIST motion.
Page 11
1. Separate the Air Hose (15) from both the head unit and the gun. Unclip the head unit from the >>>Gemini Bucket (25) (Fig.21) and remove the paint Pick-Up Tube (18b) (Fig.22). Clean the Pick- >>>Up Tube (18b) thoroughly using the Bottle Brush (#12, box checklist). Also remove Filter Cage >>>(18c) and clean thoroughly.
Page 12
Tip: Squeeze and flex the Paint Tube (13) to remove all the paint from inside the tube. 5. Wipe any excess paint off the Gemini Bucket (25) and head unit with a warm damp cloth. This will ensure your SprayStation Gemini is ready for your next painting project.
Page 13
2. Push the Rigid Pick-Up Tube (11) firmly into the base of the spray gun body. Screw the Paint Pot (12) onto the spray gun body tightly. 3. Set Paint Flow Adjuster (8) to lowest setting. 4. Uncoil the Air Hose (15) and attach it to the back of the spray gun and the other end to the SprayStation Gemini . Uncoil the power cord and ®...
Fluid Tips and Needles (applies to spraying with the Paint Pot only) The fluid tip and needle that is supplied with your spray gun is ideal for most applications, however if you want to use you SprayStation Gemini ® achieve a finer finish when spraying a material such as polyurethane, varnish or lacquer we recommend you invest in a fine finish tip and needle (see the Needle chart below).
Needle Selection Guidelines Note: To use the 1mm and 1.5mm needles you will need to include the Standard V-gun Air Cap and Spray Pattern Adjuster. Needle/ Fluid tip size Material sprayed Tip HVACGEM10 - 1.0mm (0.04”) ultra fine finish tip Acrylics, Synthetics, Polyurethane, Thinners, Lacquers, Oil-Based Stains and needle kit Tip HVACGEM15 - 1.5mm (0.06”) fine finish tip...
Page 16
Q2. What you should do before disconnecting the paint tube. A2. Prior to removing the Paint Tube (13) from the unit release pressure in the tubing by squeezing the trigger slowly into the Gemini Bucket (25). Q3. How do I fit the gun into the docking station? A3.
& paint tube), as are the following accessories; paint stirrer, faucet connector, connection plate, hose clips & bottle brush. This warranty does not affect your statutory rights. Earlex Inc will accept no responsibility for the use of this product if used for any...
Need help?
Do you have a question about the GEMINI and is the answer not in the manual?
Questions and answers