Faults, What To Do - Siemens WM14Y890GB Instruction Manual And Installation Instructions

Faults, what to do?

Faults
Water is running out.
Water not flowing in.
Detergent not
washed in.
Washing-machine
door cannot be
opened.
Programme does
not start.
Detergent solution is
not drained.
Water not visible in
the drum.
Spin result not
satisfactory.
Washing wet/too
damp.
Spin cycle actuated
several times.
Residual water in the
dispenser for care
product.
Odour formation in
the washing
machine.
Loud noise
formation, vibrations
and "wandering"
during spin cycle.
50
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
Ü
– Start/Reload
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 47
– Supply hose kinked or jammed?
– Safety function active. Stop programme?
$
– Rinse Hold (without final spin) selected?
– Can be opened via emergency release only? ~ Page 48
Ü
– Start/Reload
– Door closed?
– Childlock active? Deactivate.
$
– Rinse Hold (without final spin) selected?
– Clean the drain pump.
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
æ
– Less Ironing
– Too low speed selected? ~ Page 23
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert.
Run Cotton 90 °C programme without washing.
Use standard detergent.
– Appliance aligned?
Align the appliance. ~ Page 65
– Appliance feet fixed?
Secure appliance feet. ~ Page 65
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 59
not selected?
or Finish in time selected?
selected?