IBM xSeries 330 Hardware Maintenance Manual page 120

•
•
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
•
•
•
Dispose of the battery as required by local ordinances or regulations.
•
CAUTION:
When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic devices, or
transmitters) are installed, note the following:
•
•
112
Hardware Maintenance Manual: xSeries 330
Connect and disconnect cables as described in the following table when
installing, moving, or opening covers on this product or attached devices.
To Connect
1. Turn everything OFF.
2. First, attach all cables to
devices.
3. Attach signal cables to
connectors.
4. Attach power cords to
outlet.
5. Turn device ON.
Statement 2
Throw or immerse into water
Heat to more than 100 C (212 F)
Repair or disassemble
Statement 3
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable parts
inside the device.
Use of controls or adjustments or performance of procedures other than those
specified herein might result in hazardous radiation exposure.
To Disconnect
1. Turn everything OFF.
2. First, remove power
cords from outlet.
3. Remove signal cables
from connectors.
4. Remove all cables from
devices.