KaiCong SIP1201 User Manual page 29

KaiCong-Nothing important than safety！
WiFi connection to LAN
After finishing the wired connection as chapter 2.1, you can connect the camera by
WiFi.
Login camera in wired connection and enter wifi setting, and then operate as the
following step, example of figure 5.
Figure 5
Select 'On' and click 'Search', and then select wireless router in pop up menu,
click 'OK' and enter its password, click 'apply' to save the wireless settings.
And you can click 'check' to check if the wireless setting is successful. After
setting successfully, please pull out network cable and reboot the camera to use
the wireless function.
Because the camera supports WPS/QSS, you can set wireless by simple way as below.
Please confirm if the router which is connected to camera supports WPS/QSS (you can
check user manual of the router or get the support from router factory);
Press WPS/QSS button on the router, it will launch the function.
Press and hold on reset button for 2~5 seconds after it ran normally（not need connect
cable）, it will launch the WPS/QSS function, then match the setting with the router,
the status LED always on when it was matching, and it will flash after matching
successfully.
Unplug power adaptor and reboot the camera, then you can use the wireless connect
function.
Note: The camera will automatically stop the function when the matching is
unsuccessful after continuing 50 seconds. Due to different kinds of the router, we
are not sure our camera can be connected to all routers successfully.
Anything else ,please contanct me.