Toshiba TCB-AX21UL Owner's Manual page 16

Wireless remote controller kit
How to Match the Address
Setup to remote controller address
1. When keeping
remote controller and the present address is displayed with flashing.
2. Every pushing
them with the address switch of the indoor unit sensor to be handled.
3. When pushing
If the address matches with the address switch of the operation part, the buzzer sounds.
Display of remote
controller address
Address switch position
of signal receiving unit
The address switch is inside the face plate of signal receiving unit.
Contact the dealer for setting of the switch.
Turn the switch to left for 1, 2 and 3, and right for 4, 5 and 6.
A
15-EN
pushed for 4 seconds or more,
ADR
, the address is exchanged as ALL → 1 → 2 → 3...→ 6 → ALL. Match one of
ADR
, the address display goes on and is displayed for 5 seconds.
Address Address
* Address
switch of
signal
receiving
unit can be
set any
position.
Screw
Remove
lamp goes on at the display section of the
ADR
Address
1
2
3
4
5
6
Signal receiving unit
Face plate
– 15 –
Owner's Manual
Address
A