Viper 3000 Installation Manual page 29

3-12 CHANNEL 6 LINKING (NONE)/ARM, DISARM, BOTH: See Feature 3-6.
3-13 PARKING LIGHT SUPERVISION (ON)/PARKING LIGHT SUPERVISION (OFF):
When programmed ON the parking lights will illuminate for 30-seconds after disarming the
system, or turning off the ignition.
3-14 IGNITION CONTROLLED 2ND UNLOCK (PROGRESSIVE)/IGNITION
CONTROLLED 2ND UNLOCK (IMMEDIATE - WITH FIRST UNLOCK): When
Progressive 2 nd unlock is ON the 2
the 2 unlock occurs at the same time as the 1
nd
Transmitter/Receiver Learn Routine
The system comes with two transmitters (one 2-way and one 1-way remote) that have been taught
to it. The system can store up to four different transmitter codes in memory. Use the following learn
routine to add transmitters to the system or to change button assignments if desired.
If the system was previously programmed using the 998T Bitwriter
If the siren generates one long chirp when attempting to program the unit, the learn routine is locked
and must be unlocked using the 998T Bitwriter
1. O O p p e e n n a a d d o o o o r r . . (The GREEN wire, H1/5, or the VIOLET, H1/6 must be
connected.)
2. T T u u r r n n t t h h e e i i g g n n i i t t i i o o n n o o n n . . (The YELLOW wire, H1/9 must be connected.)
3. S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r c c h h a a n n n n e e l l : : Press and release the Valet/Program button the
number of times necessary to access the desired channel.
N N O O T T E E : If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4 position
prior to programming other channels.
© 2005
Directed Electronics, Inc.
nd unlock activates after the 1
unlock.
st
before proceeding.
®
st unlock. When Immediate is ON
, the learn routine may be locked.
®
29