Chapter 9 Notes on using the ADA-91270-90340-100PFV V1.0
9 Notes on using the ADA-91270-90340-100PFV V1.0
9.1 Stand-alone mode
The MB91F272 does not have an internal power-on reset circuitry. Therefore, when using
the MB91F272 on the ADA-91270-90340-100PFV in stand-alone mode, a reset must be
generated externally after powering-up the board.
9.2 PCB History
Pin11 and GND are swapped in the layout
Dip-Switch pins may be shorted by heat-sink of U9 (FLASH-CAN-100P-340)
For use with MB96340 an additional capacitor (C29A=10uF) has to be soldered.
(See chapter 7 for details)
© Fujitsu Microelectronics Europe GmbH
- 19 -