Connection - Digimerge DND13TL2 Instruction Manual

2. CONNECTION

The camera has the following termination cables:
1. RJ45 Network Interface: Connect to a router or switch on your network
using RJ45 Ethernet cable (Cat5e or better). 100Mhz connection. PoE
supported (class 3 PoE switch required).
NOTE: Use the included RJ45 coupler to connect to male end of RJ45
Ethernet cable.
2. Audio Input (RCA): Connect to a self-powered microphone for listen-in
audio.
3. Audio Output (RCA): Connect to an amplifier or self-powered speaker for
intercom/2-way audio.
4. DC12V (1A): 12V DC power input terminal. Make sure to follow correct
polarity (+/-) marked on the power connector when connecting to power.
• Minimum Power Requirement: 450mA / 5.4W.
RJ45 Coupler
Connection
5