Washer Care; Cleaning Your Washer - Whirlpool WASHER Use & Care Manual

Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Cleaning the interior
Use the following procedure without any clothing. Your washer
interior should be cleaned at least once per month to reduce or
prevent any accumulation of mold or mildew odors.
Start by adding 1 cup (250 mL) of bleach into the detergent
dispenser. Continue by adding 1 cup (250 mL) of bleach
directly to the wash tub. This is the only time you should add
anything other than clothing into the wash tub. Select and run
the Regular/Heavy Soil cycle without clothing, using hot
water. Repeat this process if necessary.
Inspect the interior of the washer for lint and other debris that
may accumulate on the basket and rubber bellows. Remove
and dispose of any accumulation as necessary.
Leave the washer door open between cycles to allow the
washer interior to dry out.
NOTE: To remove hard water deposits, use only cleaners labeled
for washer use.
Cleaning the door seal
Use a soft damp cloth or sponge when necessary. Check the fold
of the seal periodically for any foreign objects.
Cleaning the dispenser drawer
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing on the plastic part
of the softener compartment marked "PUSH."
A. Dispenser drawer release
2. Remove the drawer.
3. Do not clean the door with cleaning solvents or abrasive
cleansers. You could damage the finish.
4. Replace the dispenser drawer in the washer.

WASHER CARE

Cleaning Your Washer

The lint filter should be cleaned about once a month. Make sure
the washer has drained before opening the filter door.
1. Place a pan or towel under the filter door, since a small
2. Remove the filter by rotating it a half-turn counterclockwise
3. Clean the filter with a soft brush under running water until all
4. Replace the filter and turn it clockwise until it is securely
A
To clean the control panel, use only a warm, damp cloth.
Cleaning the lint filter
amount of water could spill.
and pulling outward.
residue is removed.
locked in place. Give the cap a gentle tug to confirm that the
filter is secure.
Cleaning the control panel
Do not spray water or cleaning solvents on the control panel.
Do not use abrasive cleaners or scouring pads on the outer
surfaces because they will scratch the finish and could
remove the writing on the control panel.
Some paper towels may also scratch the finish.
15