Table of Contents
Advertisement
∫ About the convergence point
Convergence point is a position that becomes the reference plane of the 3D image.
When viewing the 3D image, a subject located closer than the convergence point is
displayed in front of the screen, and a subject located farther than the convergence point is
displayed behind the screen.
∫ Adjusting the convergence point
To ensure that the 3D image can be safely viewed, pay attention to the following
points when adjusting the convergence point.
≥ The image may cause tiredness or discomfort when adjustment of the convergence point
is frequently performed, or the position of the subject is further away in front or rear of the
convergence point or at the edge of the image.
≥ Stop the operation when you feel fatigue, discomfort, or otherwise strange while
adjusting.
It is recommended to prepare for recording, such as adjust the convergence point in
accordance with the position of the subject in advance, determine the construction of the
image to record, etc., to record an image that is effective as 3D video. It is also
recommended to adjust the convergence point again when the distance between this unit
and the subject is changed significantly.
1
Display the convergence.
MENU
: [SW & DISP SETUP] # [CONVERGENCE] # [ON]
2
Rotate the CONV. dial to adjust the
convergence point.
≥ This can be set between C00 and C99. Position of the
convergence point will be set further when the number
is larger.
≥ The subject at the position of the convergence point will
not shoot out or recess from the screen. (It will be seen
in the same way as 2D image.)
≥ Adjust by checking on the 3D video or 3D guide display
on the LCD monitor. (l 28)
≥ When zooming, it may be necessary to readjust the convergence point.
CONV.
27
(ENG) VQT3V01
Advertisement
Table of Contents
