Brother MFC-J825DW Quick Setup Manual page 22

Wired Network
For wired network interface users
14
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
Note
• For Mac OS X 10.4.0 to 10.4.10 users, upgrade
to Mac OS X 10.4.11 - 10.6.x.
• If you have previously set up your machine for
a wireless network and then want to set it up on
a wired network, you should check that the
machine's Network I/F is set to
Wired LAN. The wireless network interface
will become inactive with this setting.
On your machine, press Menu.
Press Network.
Press Network I/F.
Press Wired LAN.
Press Stop/Exit.
15
Connect the network
cable
a
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
22
(Mac OS X 10.4.11, 10.5.x, 10.6.x)
b
You will find the Ethernet port marked with a
symbol inside the machine on the left as
shown below. Remove the protective cap and
connect the network cable to the Ethernet port.
c
Carefully guide the network cable into the cable
channel and out the back of the machine.
Connect the cable to your network.
IMPORTANT
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both the USB and the LAN cables are being
used, guide both cables through the cable
channel with one on top of the other.
Macintosh
USB