Advertisement
ASSEMBLY cont.
PAPER PUNCH (See Figure 4)
A paper punch template is included with sander so you can punch properly aligned holes
into the sandpaper. This is done after the paper is installed onto the sander.
To punch holes, line up the front and side of the sander over the paper punch template as
shown in Fig. 4, then lower the sander onto the template while applying pressure. Make
sure the holes are punched all the way through the paper and clear the holes in the
sander's cushion and platen.
NOTE: Punching holes properly is a necessary step for the dust collection
system to operate properly.
Fig 4
TO REMOVE AND EMPTY DUST BAG (See Fig. 5, page 15)
1. Unplug the sander.
WARNING:
!
Failure to unplug the sander could result in accidental starting
causing possible serious personal injury.
2. Remove dust bag assembly from the sander by pulling it straight back and out of the
sander (see Fig. 5, page 15).
14
ASSEMBLY cont.
TO REMOVE AND EMPTY DUST BAG cont. (See Fig. 5)
3. Remove the dust bag / wire adapter from the dust bag assembly by sliding it down
and out of the slots in the assembly (see Fig. 5a).
4. Remove the bag from the wire frame and shake aggressively to completely empty the bag.
(see Fig. 5b)
Fig 5
Fig 5a
Orient Paper Punch
as shown
5. When the bag is empty attach bag back onto the wire frame adapter (see Fig. 5b).
Make sure the bag is fastened up to, and tightly around, the adapter.
6. Slide dust bag / wire adapter up into the slots on the dust bag assembly (see Fig. 5a)
until they snap into position.
7. Attach dust bag assembly back into the sander.
8. Your sander is now ready to use.
NOTE: Empty dust bag frequently when sanding so dust collection system
works properly
Dust Bag
Assembly
Dust Bag
Dust
Adapter
Exhaust Hole
Fig 5b
15
Advertisement
