Table of Contents
Advertisement
Installing Windows NT and Windows 2000
Perform the following steps to install Windows NT 4.0 or Windows 2000 on the
drive that is attached to the IBM FAStT Host Adapter.
1. Insert the Windows NT or Windows 2000 setup diskette or insert the Windows
2. After the standard devices have been detected and configured, use the S
3. Select Other; then, press Enter.
4. Insert the FAStT Host Adapter device driver diskette that you created in
5. Select QLogic QLA2200; then, press Enter.
6. Select the standard installation procedure.
Adding the Windows NT driver
Perform the following steps to add the Windows NT device driver to a previously
installed Windows NT 4.0 system.
1. On your desktop, click My Computer → Control Panel → SCSI Adapters.
2. Click the Drivers tab and click Add.
3. Select QLogic from the list of manufacturers and click Have Disk.
4. Insert the IBM FAStT Host Adapter driver diskette you created for Windows NT.
5. If you are installing the drivers from a CD-ROM, at the prompt type:
6. Select IBM Netfinity QLA2200 PCI Fibre Channel Adapter and click OK.
7. Click Yes to restart your server so the driver settings can take effect now or
16
FAStT Host Adapter Installation and User's Guide
NT or Windows 2000 installation CD into the CD-ROM drive.
option to Specify Additional Device.
Chapter 4; then, press Enter.
At the prompt type:
a:\nt
where a is the diskette drive letter. Click OK.
z:\NT4\22 \NT
where z is the CD-ROM drive letter.
click No to restart your system at a later time.
Advertisement
Table of Contents
