Table of Contents
Advertisement
Wired - Manual
If you have a static IP address or the Automatic procedure does not work, you'll
need to set the
Network Settings
Follow Steps 1 and 2 in Wired - Automatic and then follow these steps:
1.
Select
Network
the connection failed message.
2.
On the bottom of the screen, select
The
IP Settings
3.
Select the IP Setting field, and then press the
4.
Select
Enter manually
5.
Select a value to enter
button. Use the number keypad on your remote control to enter the numbers
for the value. You can also enter numbers using the ▲▼ buttons. Use the ◀▶
buttons on the remote control to move from entry field to entry field within a
value. When done with one value, press the
6.
Press the ▲ or ▼ button to move to another value, and then enter the numbers
for that value following the instructions in Step 5.
7.
Repeat Steps 5 and 6 until you have filled in all values.
"
You can get the Network values from your Internet provider.
8.
When finished entering all the values, select OK, and then press the
The product verifies the network connection and then connects to the network.
values manually.
Status. The product searches for a network, and then displays
screen appears.
in the IP Setting field, and then press the
(IP
Address, for example), and then press the
IP
Settings, and then press the
E
button.
E
button.
E
button.
E
button.
E
E
button.
Hide quick links:
Advertisement
Table of Contents
