Integrated Peripherals - Gigabyte GA-D525TUD User Manual

2-5

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
SATA AHCI Mode
Azalia Codec
Onboard H/W LAN
Green LAN
 SMART LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
USB 1.0 Controllers
USB 2.0 Controllers
USB Keyboard Function
USB Mouse Function
USB Storage Function
: Move Enter: Select
F5: Previous Values
& SATA AHCI Mode
Allows you to decide whether to configure the SATA controller integrated in the Chipset to AHCI mode.
Configures the SATA controller to IDE mode. (Default)
IDE
Configures the SATA controllers to AHCI mode. Advanced Host Controller Interface
AHCI
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
& Azalia Codec
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
& Onboard H/W LAN
Enables or disables the onboard LAN function. (Default: Enabled) If you wish to install a 3rd party add-in
network card instead of using the onboard LAN, set this item to Disabled.
& Green LAN
When the onboard LAN function and Green LAN are enabled, the system will dynamically detect if a LAN
cable is connected or not. If not, the corresponding LAN controller will be disabled automatically. (Default:
Disabled)
& SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Start detecting at Port.....
Part1-2 Status = Open / Length =
Part3-6 Status = Open / Length =
Part4-5 Status = Open / Length =
Part7-8 Status = Open / Length =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to
the following information for diagnosing your LAN cable:
Integrated Peripherals
[IDE]
[Auto]
[Enabled]
[Disabled]
[Press Enter]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Enabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
SMART LAN
0m
0m
0m
0m
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 19 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults