Using The P In P Function; Using The Function Button; Using The Status Function; Using The Eco Management Function - Panasonic PT-EZ580 Operating Instructions Manual

Chapter 3 Basic Operations — Operating with the remote control

Using the P IN P function

Locate a separate, small sub screen in the main screen to project two images simultaneously.
button
1) Press the <P IN P> button.
f The setting will change each time you press the button.
Note
f Refer to the menu [P IN P] menu (x page 98) for details.

Using the function button

[SUB MEMORY], [SYSTEM SELECTOR], [DAYLIGHT VIEW], or [TEST PATTERN] operations can be assigned to the <FUNCTION> button on
the remote control so that it can be used as an easy shortcut button.
button
1) Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 92).

Using the status function

You can display the status of the projector.
button
1) Press the <STATUS> button.
f The [STATUS] screen is displayed.
Note
f This can be displayed from the [PROJECTOR SETUP] menu → [STATUS] (x page 94).

Using the ECO management function

You can display the setting screen relating to ECO management.
button
1) Press the <ECO> button on the remote control.
Note
f Refer to the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] (x page 87) for details.
STATUS
INPUT
RGB2
SIGNAL NAME
SXGA60+-A1
SIGNAL FREQUENCY 65.22kHz/ 59.99Hz
PROJECTOR RUNTIME
1h
LAMP: ECO
100h
: NORMAL
200h
: TOTAL
300h
INTAKE AIR TEMP.
27°C/ 80°F
AROUND LAMP TEMP. 27°C/ 80°F
SEND STATUS VIA E-MAIL
ENTER
CHANGE EXIT
MENU
1/4
ENGLISH - 55