How Your Humidifier Works; Assembly, Controls & Operation - Essick 821 000 WHITE- DIGITAL CONTROL Owners Care And Use Manual

HOW YOUR HUMIDIFIER WORKS

Dry air is drawn into the humidifier though
the back and moisturized as it passes
through the evaporative wick. It is then
fanned out into the room.
1. Water reservoir
2. Chassis/power pack
(motor/fan assembly)
CAUTION: Do NOT position the unit directly in
front of a hot air duct or radiator. Do NOT place
on soft carpet.
ASSEMBLY, CONTROLS & OPERATION
1. Unpack humidifier from carton.
2. Remove all packaging materials. Check to see that you have all of the
following items removed from the boxes accessory kit and cabinet before
discarding the packaging:
♦ Evaporative wick & Wick Retainer
♦
Lift rod assembly with Styrofoam float
CASTERS
3. Turn the emptied cabinet upside down. Insert each caster stem into one of
the four caster holes on the corner of the humidifier bottom. The casters
should fit snugly and be inserted until the stem shoulder reaches the cabinet
surface.
4. Turn the cabinet right side up.
EVAPORATIVE WICK
5. Replace the float assembly and attached lift
rod into the boxed area on the bottom of the
inside of the cabinet. Slip lift rod into retainer
ring and twist to secure. The lift rod should
be able to freely move up and down about
3/8". The retainer ring should be located
between the two ribs on the lift rod.
6. Place the wick assembly back into the
guides provided in the bottom of the
cabinet and the ribs along the sides.
7. Place the chassis unit onto the cabinet
ensuring that the chassis seats correctly
into the front and back grooved edges.
LEGEND:
3. Evaporative wick
4. Dry air intake
5. Moist air output
♦ Caster kit
♦ Manual
3