Ford 2006 Explorer Owner's Manual page 220

Ford explorer 2006
Hide thumbs Also See for 2006 Explorer:
Table of Contents

Advertisement

Driving
carownersmanual.net
carownersmanual.net
AdvanceTrac with RSC button and icon functionality
The AdvanceTrac with RSC system automatically turns on each time
the engine is started, even if it was turned off when the engine was last
shut down. The "sliding car" icon which is located with the warning
lights in the instrument cluster will illuminate during bulb check at initial
start-up and then go off. This tells you that the system is normal and
active. All functions of the AdvanceTrac with RSC (RSC, ESC, Engine
Traction Control, and Brake Traction Control) will be activated at start
up. When the system is left active, the "sliding car" icon will flash only
when any of the components of the system are affecting the vehicles
performance, otherwise the light will remain off. Consequently, the
"sliding car" icon will not be illuminated during most of your normal
driving.
The AdvanceTrac with RSC button,
located on the center stack of the
instrument panel, allows the driver
to control certain features of the
AdvanceTrac with RSC system
below 25 mph (40 km/h). If the
vehicle is below 25 mph (40 km/h), momentarily pressing the
AdvanceTrac with RSC button will disable RSC, ESC and Engine
Traction Control and steadily illuminate the "sliding car" icon. Pressing
and holding the AdvanceTrac with RSC button for more than five
seconds will further disable the brake portion of the Traction Control
feature and the "sliding car" icon will flash momentarily and then
illuminate steady.
If the vehicle is above 25 mph (40 km/h), momentarily pressing the
AdvanceTrac with RSC button will steadily illuminate the "sliding car"
icon, however, the AdvanceTrac with RSC system will remain enabled
until the vehicle speed drops below 25 mph. If the vehicle speed
decreases below 25 mph (40 km/h), the system will become deactivated,
but if the vehicle speed subsequently increases to above 25 mph (40
km/h), the system will again become active. In general, the system will
be active at all times the vehicle speed is above 25 mph (40 km/h).
In R (Reverse), ABS and the Traction Control feature will continue to
function, however ESC and RSC are disabled.
All these conditions are normal during AdvanceTrac with RSC
operation. Refer to the following table.
220
2006 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents