Ford 2006 Explorer Owner's Manual page 108

Locks and Security
carownersmanual.net
carownersmanual.net
Switching from two step to one step door unlocking
Your vehicle comes with two step unlocking enabled. Unlocking can be
switched between two step and one step door unlocking by pressing and
holding both the
transmitter for approximately 4 seconds. The parklamps will flash twice
to indicate that the vehicle has switched to one step unlocking. Repeat
the procedure to switch back to two-step unlocking.
Locking the doors/liftgate
1. Press
flash. Note: If any door, the liftgate or the liftgate glass are not closed
properly, the lamps will not flash.
2. Press
doors are closed and locked. Note: The doors will lock again, the horn
will chirp and the lamps flash once.
Note: If any door, the liftgate or the liftgate glass are not closed
properly, the horn will make two quick chirps.
Opening the liftgate window
Press
Sounding a panic alarm
Press
will flash for a maximum of 3 minutes. Press again or turn the ignition to
the 3 (ON) position to deactivate, or wait for the alarm to timeout in 3
minutes.
Note: The panic alarm will only operate when the ignition is in the 1
(OFF/LOCK) or 2 (ACC) position.
Memory seats/adjustable pedals/easy entry-exit feature
(if equipped)
The remote entry system can also control the memory seat /adjustable
pedals/easy entry-exit feature.
Press to automatically move the seat and adjustable pedals to the
desired memory position (the seat position corresponds to the
transmitter being used).
108
2006 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)
and buttons simultaneously on the remote entry
and release to lock all the doors and liftgate. The lamps will
and release again within three seconds to confirm that all the
to unlatch the liftgate window.
to activate the alarm. The horn will sound and the parklamps