Compliances - IBM G94 User Manual

Federal Communications Commission
(FCC) Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:

Compliances

Reorientate or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult an IBM authorized dealer or service
representative for help.
Properly shielded and grounded cables and
connectors must be used in order to meet FCC
emission limits. Proper cables and connectors are
available from IBM authorized dealers. IBM is not
responsible for any radio or television interference
caused by using other than recommended cables
and connectors or by unauthorized changes or
modifications to this equipment. Unauthorized
changes or modifications could void the user's
authority to operate the equipment.