Adjustments; Adjustment Of The Footrest (Fig. 10.1); Width Adjustment Of The Footrests; Adjustment Of The Armrests - Quickie Tango Instructions For Use Manual

10.0 adjustments:

10.1 adjustment of the footrest (fig. 10.1):

To adjust the height of a footrest:
Loosen the screw, using a 4.0mm Allen key and set the
footrest at the height desired, then tighten the screw in
the hole.
note: Make sure that the screws are tightened securely.

10.2 width adjustment of the footrests:

To adjust the width between the footrests, use a size
10.0 mm spanner to loosen the hexagonal bolts on the
adjustable footrest frame. These are located at the front of
the seat frame. Pull the footrests outwards or inwards to
achieve the desired position. Tighten the bolts securely.
Make sure that the bolts are secured with the locking-
nuts.
wIdth
adjustement
bolts

10.3 adjustment of the armrests:

height adjustment (fig. 10.3):
Set the screw in the hole of the armrest tube that
corresponds with the desired height. Turn the handle
clockwise to tighten.
38
Quickie Tango
Screw on
Inside
seat width adjustment (fig. 10.4):
To adjust the width between the armrests, use a size 10.0
mm spanner to loosen the hexagonal bolts on the armrest
adapter retainers, which are located on the side frame
below the armrests, and pull the armrests outwards or
inwards to achieve the desired position. Tighten the bolts
securely. Make sure that the bolts are secured with the
locking-nuts.
fig. 10.1

10.4 seat depth adjustments:

(Fig. 10.5). Remove the 2 bolts on the backrest brackets
1 for each side of the frame, using a 5.0mm Allen key
and 13.0mm spanner. Move the backrest into the seat
depth position required. Put the bolts back and tighten
them up. To compensate for the armrest position, use a
combination of the bolt adjustment under each armpad
and swapping the armrest retainers from left to right, to
fig. 10.2
achieve a forward or rearward bias.
There are 4 Seat depths; 42.5, 45, 47.5, 50mm.
The Four adjustments are:
• 42.5mm: Armrest retainer forward biased and
armpad fixed fully forwards.
• 45mm: Armrest retainer forward biased and armpad
fixed in the fully backwards position.
• 47.5mm: Armrest retainer rearward biased and
armpad fixed fully forwards.
• 50mm: Armrest retainer rearward biased and armpad
fixed in the fully backwards position.
Handle
10.0mm
Bolts
fig. 10.4
fig. 10.3