Table of Contents
Advertisement
Troubleshooting
If you suspect something is not working correctly, you should :
The LCD contains over
3,900,000 thin-film
transistors (TFTs). A small
number of missing, discolored, or
lighted dots may be present on
the screen, which is an intrinsic
characteristic of the TFT LCD
technology and is not an LCD
defect.
1.
Turn on the computer and monitor.
2.
Set the brightness
3.
Ensure that all cables are securely connected.
4.
Disable standby mode if it is enabled. Push the setup switch on the
back of the monitor to determine whether standby mode is enabled.
5.
Disable the computer's screen saver program if it is enabled.
6.
Run the auto setup procedure described in Configuring your Monitor
on page 8
7.
If there is screen noise, adjust the PHASE parameter in the
Intermediate Controls on page 32.
Adjust the CLOCK parameter in the Intermediate Controls on page 32
8.
to suppress the display of vertical stripes.
9.
If you are using an RS/6000 with composite output function, do not
specify 'DPMS' to the STANDBY parameter in the Basic Controls on
page 31.
10. To restore all the auto setup settings to the original values in effect when
the monitor was shipped, perform SYSTEM RESET in the Intermediate
Controls on page 32, or press each minus button of the brightness and
the contrast control simultaneously and turn on the monitor. Both LED
indicators turn on and off, and all settings are restored.
11. Set the screen mode to the Supported Screen Addressability in the
table on page 38.
12. Perform AUTO SETUP for each display mode (each screen resolution).
13. On this monitor, different from a CRT, faster refresh rate does not make
the screen quality better. Using the monitor with a refresh rate of 60 Hz
with noninterlace is recommended.
35
control to the proper position.
Advertisement
Table of Contents
