Table of Contents
Advertisement
T54A-E.book Page 12 Saturday, February 19, 2000 12:05 PM
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
12
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
setup diskette does not run on your system, perform
1.
Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2.
Display the image you most frequently use on the screen.
3.
Press the OSD Enter button
the initial OSD menu.
4.
Use an Arrow button (
and press the OSD Enter button
5.
Using an Arrow button (
press
once to select
indicators become illuminated (see page 16
6.
Use the Arrow buttons to manually adjust to correct (as much as
possible) for noise in the video signal then press
changes.
7.
Use an Arrow button to select
8.
Use the Arrow buttons again to tune the image to your liking.
9.
When finished, press the Exit button
OSD.
You have completed the monitor setup.
Manual Setup
A
A
M
ANUAL
at the bottom of the monitor to display
or
) to select the IMAGE LOCK icon
to access the function.
or
), select
MANUAL
. Left and right arrow adjustment
COARSE
).
and press the
FINE
four times to exit from the
, however,
S
UTO
ETUP
or the
S
UTO
ETUP
.
S
ETUP
, press
and then
to save the
button.
Hide quick links:
Advertisement
Table of Contents
