Connecting Your Monitor; Switching On Your Monitor - IBM 9511-A Series User Manual

15-inch tft lcd monitor
Table of Contents

Advertisement

T54A-E.book Page 5 Saturday, February 19, 2000 12:05 PM

Connecting your Monitor

Be sure to read the 'Safety
Information' at the front of
this User Guide before
carrying out this procedure.
The AC adapter and signal
cable are connected to
your monitor. If you wish to
change these or to fit a different
stand, see Further Help on
page 22.

Switching on your Monitor

1.
Turn off your PC and all attached devices.
2.
Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card may be colored blue to match the blue
connector on your monitor's video cable.
3.
Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked
.
To switch off your monitor, push and release the power switch again.
3.
Turn on the monitor and then the computer.
by following the instructions in the Configuring your
4.
Run
A
S
UTO
ETUP
Monitor section on page 6.
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

T540T54a

Table of Contents