Setting The User Program - Arlec PEH002 User Manual

SETTING THE USER PROGRAM (UP)
END
SETTING THE USER
PROGRAM (UP) FOR THE
WEEK
PROGRAMMING THE
ECONOMY AND COMFORT
PERIODS
PROGRAMMING A 24
HOUR DAY
COPYING THE 24 HOUR
PROFILE
ENDING THE PROGRAMING Press the "PROG" button.
PEH002 Instructions.indd 9
STEPS (Refer to Fig.3)
Press Program Selection 'p'
button "5".
Use the UP and DOWN
buttons to select the
program "UP".
Press the programming
button "PROG" "6"
Press program selection 'p'
button "5"
To set the UP program to
start on a specific day:
Press the TIMER button "8"
repeatedly until the correct
day is selected.
Use either the DOWN
button "10" to enter
the required Economy
periods or the UP button
"11" to enter the required
Comfort periods. The
timer Advances in 30min
intervals.
Complete the
programming for the
whole 24 hour day with
Economy and Comfort
Periods.
Press timer button to
proceed to next day.
If the same 24 hour profile
applies for several days in
the week. Press the TIMER
button "8" to select the day
to be copied.
-Press the COPY button "9".
-Press the TIMER button "8"
to the desired day.
-Press the COPY button "9"
to complete.
9
DIGITAL DISPLAY (Refer to
Fig.4)
The display will show the
day, the Pre Set Program,
temperature and program
sequence.
The program "UP will flash.
The program "UP" will stop
flashing.
The Selected "day" will be
shown.
The Comfort period units
displayed in the program
will be replaced by
Economy period units when
the DOWN button "10" is
released, the next Comfort
period unit will flash.
After programming the
full 24 hours, the timer will
display 00:00 (midnight).
The unit is now ready for
programming the next
24 hour day. You must
complete a 24 hour profile
before it will take effect.
"COPY" will be shown and
the "day" will flash.
This will display the day
that you wish to copy the
program. The "day" will
flash.
The word "COPY" will
disappear and the "day"
will stop flashing.
Will show the current
program.
22/12/09 2:30:12 PM