Cleaning The Truman Cell - Oreck AIRP Series User Manual

Cleaning the Truman Cell

Note: The Truman Cell
snapping sound that occurs when large particles of dust are collected in the Truman Cell
or continuous arcing occurs the Truman Cell
7
9
IMPORTANT: Do not try to clean the Truman Cell
the cell plates.
Unplug the air purifier.
1
Remove the top cover by sliding forward and lifting off.
2
Pull the Truman Cell
3
of the Truman Cell
4 Based on the frequency of arcing or how dirty the cell has become, perform one or both of the following steps:
If the cell is arcing frequently a "quick clean" can be performed by gently wiping a dry cotton swab
5
along the length of each of the four wires near the front of the cell to remove any built-up particles
from the wires. Go to Step 9.
For a more complete cleaning, place the Truman Cell
6
cleaner and contaminants will rinse away without damaging surfaces and proceed to Step 7.
Spray Oreck Assail-a-Cell
7
surface. Allow the cleaner to soak for a few minutes and rinse with clean water. Do not let the
cleaner dry on the Truman Cell
An alternative method to clean the Truman Cell
Mild liquid dish detergent may be used to help break down dirt. Rinse thoroughly with clean water.
Note: Do not put in dishwasher or insert objects to clean the Truman Cell
Tough residue such as tar from tobacco smoke may need additional applications or longer soaking.
Allow to dry completely outside of the air purifier. Do not use heated or compressed air to dry.
8
IMPORTANT: Do not reinsert the Truman Cell
Cell" light blinks red after replacing the Truman Cell
Remove the Truman Cell
Place the Truman Cell
9
is specially designed so that it can be inserted only in one direction.
Replace the top cover, sliding back to lock into place. Be sure the top cover and front grill are
1
securely closed or the unit will not operate.
Reset the "Check Collector Cell" timer by holding down the Air Revitalizer button until the "Check
11
Collector Cell" light blinks three times.
E N
™
™ may require more frequent cleaning if "arcing" occurs. Arcing is a sharp
™ straight up and out of the cabinet by using the two small handles on each side
™ .
®
cleaner thoroughly between each cell plate and cover each
™ .
™ and allow it to finish drying.
™ back into the unit by sliding it straight down into the slots. The Truman Cell
G L I S
™ should be cleaned.
2
3
™ by inserting a cloth, brush, or other object between
™ in a sink, bathtub or other location where
™ is to soak it in warm water for two to three hours.
™ until it is completely dry. If the "Check Collector
™ , then the Truman Cell
9
H
5
1
11
™ .
™ may still be wet.
™ . If prolonged
™