Replacing The Charcoal Odor Absorber (Optional); Replacing Collector Cell After Cleaning - Oreck COMPACT AIR PURIFIER User Manual

5
6
Cleaning the Electronic Collector Cell:
6. Oreck's Assail-A-Cell ® cleaner is an excellent way to clean a
Collector Cell. Be sure to spray between each Cell plate and
cover every surface. Allow product to soak for a few minutes,
not allowing it to dry. Rinse thoroughly with water. For
extremely heavy deposits, repeat the process.
If you prefer not use Oreck's Assail-A-Cell
also decide to soak the Collector Cell in warm water in a
kitchen sink or bathtub. Mild dish detergent (powder or liquid)
may be added to the water to help break down the dirt on the
Collector Cell. The Collector Cell should be allowed to soak
for two to three hours.
Tobacco smoke (tar) is especially hard to remove from the
Collector Cell. If the Purifier has been cleaning tobacco
smoke, the Collector Cell may need to soak longer, or it may
need to be cleaned a second time.
In either case, the Collector Cell should be allowed to air dry
before re-inserting it. Oreck does not recommend the use of
heated or compressed air as part of the drying process.
IMPORTANT: Dry the Collector Cell thoroughly outside
of the Air Purifier before reinstalling it into the Air
Purifier. Ensure that all areas including corners and
areas that may trap water are dry before reinstalling
into the Air Purifier.
Replacing The Charcoal Odor Absorber
(Optional)
In addition to air purification, your Oreck provides the additional
benefit of odor removal. The odor removal function is optional.
Your Oreck Air Purifier will continue to remove harmful airborne
particles with its permanent Electronic Collector Cell even if you
choose not to use the optional Charcoal Odor Absorber.
Odor absorption effectiveness will gradually deteriorate over
time unless the Charcoal Odor Absorber is replaced. While
every environment is different, Oreck suggests that the Charcoal
Odor Absorber be replaced every two months or as needed.
IMPORTANT: DO NOT wash the Charcoal Odor Absorber.
Replace, if necessary.
Replacing Cell After Cleaning
1. Snap in the Charcoal Odor Absorber (fig. 5).
2. Slide in the Pre-Filter (fig. 6).
3. Slide Collector Cell into cabinet, using handles (fig. 4).
4. Replace front grill. Unit is now ready for operation (fig. 3).
NOTE: An occasional snapping or popping sound
("arcing") is normal when operating the unit immediately
after cleaning the Collector Cell and should stop after a few
minutes of operation.
Whenever calling, please be sure to have your model and serial
number from data plate.
Accessories (Sold Separately)
ITEM
1.
2.
3.
4.
® cleaner, you may
5
CALL CUSTOMER SERVICE HOT LINE
US:1-800-989-3535 Canada: 1-888-676-7325
Pre-Filter
Ionizer/Electronic Collector Cell
Charcoal Odor Absorber (Set of 4)
Oreck's Assail-A-Cell ® cleaner
USA: 800-989-3535
Canada: 888-676-7325
Outside the USA and Canada,
contact your local Oreck Distributor.
PART #
7780-8040
5510-7064
AT4PK7
32358