Table of Contents
Advertisement
Optional accessory:
FM traf¿ c receiver
SD card
GPS antenna
Steps to Install the KNA-G610
1. Remove the key from the vehicle ignition and disconnect
the negative battery cable.
2. Install the GPS antenna. Refer to the tips on the
previous page.
3. Connect the wiring harness to your vehicle in the
following order: ground, battery, ignition.
4. Connect the wiring harness to the
main unit.
5. Install the main unit. Refer to the tips on the previous
page.
6. Reconnect the negative battery cable.
n
n
CAUTION
If your vehicle ignition does not have an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source with a constant voltage
supply, such as battery wires, the navigation system could
drain your battery.
To mount the GPS antenna inside your vehicle:
1. Clean your dashboard or other surface.
2. Peel the backing off of the adhesive on the bottom of the metal
3. Press the metal plate down ¿ rmly on your dashboard or other
4. Place the GPS antenna on top of the metal plate.
n
n
WARNING
Do not connect the yellow wire directly to
the vehicle battery. Connecting directly to
the battery may cause the wire insulation
to fail and may pose a risk of short circuit
and electric shock.
Black
To vehicle chassis
2A
Red
To ignition (12 Vdc)
2A
Yellow
To battery (12 Vdc)
Installing the GPS Antenna
Best (roof of vehicle)
Good (inside car
Better (trunk
on dashboard)
of vehicle)
plate.
mounting surface. You can bend the metal plate to conform to a
curved surface, if necessary.
To display unit (NAV I/F terminal)
NOTE: The 2010 and later display unit
can be connected to this system. To
check the connectable models, go to
www.kenwood.com/cs/ce.
Ignition key switch
Car fuse box
Car fuse box
(main fuse)
Advertisement
Table of Contents
