Advertisement
l l o o n n g g t t e e r r m m e e v v e e n n t t h h i i s s t t o o r r y y
The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full trigger,
the older of the two triggers in memory will be replaced by the new trigger. To access long term event history:
1.
2.
3.
4.
N N O O T T E E : : The Warn Away triggers are not stored to memory and will not be reported.
s s a a f f e e t t y y c c h h e e c c k k
Before vehicle reassembly, the remote system must be checked to ensure safe and trouble-free operation. The fol-
lowing test procedure must be used to verify proper installation and operation of the system. The installation
must be completed before testing, including connection to the brake switch and hood switch.
1. Test the BRAKE shutdown circuit: With the vehicle in Park (P), activate the remote start system. Once the
engine is running, press the brake pedal. The engine should shut down immediately. If the engine continues
to run, check the brake circuit connection.
2. Test the HOOD PIN shutdown circuit: With the vehicle in Park (P), open the hood. Activate the remote start
system. The vehicle should not start. If the starter engages, check your hood pin and connections.
N N O O T T E E : : If programmed for Diesel Mode, the system will turn on the ignition, but the starter should
not engage with the hood open.
3. Test the NEUTRAL SAFETY shutdown circuit:
5 5 4 4
With the ignition off, press and H H O O L L D D the Valet/Program switch.
Turn on the ignition.
Release the Valet/Program switch.
Press and release the Valet/Program switch within 5 seconds. The LED will flash in groups
indicating the last two zones that triggered the unit for one minute or until the ignition
is turned off.
© 2005 Directed Electronics—all rights reserved
Advertisement
