Advertisement
H H 1 1 / / 8 8 G G R R E E E E N N ( ( - - ) ) d d o o o o r r t t r r i i g g g g e e r r i i n n p p u u t t , , z z o o n n e e 3 3
Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any
door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected
by the delay circuitry. This wire will report Zone 3.
H H 1 1 / / 9 9 B B L L A A C C K K / / W W H H I I T T E E ( ( - - ) ) 2 2 0 0 0 0 m m A A d d o o m m e e l l i i g g h h t t s s u u p p e e r r v v i i s s i i o o n n o o u u t t p p u u t t
Connect this wire to the optional domelight supervision relay as shown below:
I I M M P P O O R R T T A A N N T T ! ! This output is only intended to drive a relay. It cannot be connected directly to the
domelight circuit, as the output cannot support the current draw of one or more light bulbs.
H H 1 1 / / 1 1 0 0 W W H H I I T T E E / / B B L L U U E E r r e e m m o o t t e e s s t t a a r r t t ( ( - - ) ) a a c c t t i i v v a a t t i i o o n n i i n n p p u u t t
This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-
tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true
for the remote control activation when set to a two pulse setting it is necessary to press the
for the remote start to activate or deactivate.
N N O O T T E E : : When the activation pulse count can be programmed to 1, 2, or 3 pulses when changed
it will affect both activation inputs; the White/Blue wire and the remote control activation.
© 2005 Directed Electronics—all rights reserved
button twice
1 1 9 9
Advertisement
