Table of Contents
Advertisement
using the metal detector to
Search
1.
Set the DISC Dial (15) to All Metal
mode, and the SENS Dial (13) to
"high" position (the larger white dots).
2.
Hold the Search Coil (33) parallel
with the ground about 1" above the
surface. Sweep the Search Coil (33)
from side to side in a 3" arc.
3.
When the Metal Detector detects a
buried metal object, it sounds a beep.
Make a visual note of the exact
spot on the ground where the beep
sounds.
4.
Move the Search Coil (33) forward
and away from you and straight back
towards you a few times while ro-
tating the DISC Dial (15) clockwise
away from All Metal, until the unit
does not beep.
5.
You can then identify what type of
metal has been detected according to
the position of the DISC Dial (15).
6.
The reading on the View Meter (5)
will read higher for larger deposits of
metal.
7.
When you are finished using the
Metal Detector, turn it off. Clean the
exterior surfaces with a soft cloth,
then store it indoors in a dry place,
out of the reach of children.
listening Safely
1.
Set the volume to lowest setting
before you begin listening. After you
begin, adjust the volume to a comfort-
able level.
2.
Warning: Do not listen at extremely
high volume levels. Extended high
SKU 98760
For technical questions, please call 1-800-444-3353.
volume can lead to partial or perma-
nent hearing loss.
maintenance and
SerVicing
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
do not use damaged
equipment. if anything
abnormal occurs, have the
problem corrected before
further use.
cleaning and maintenance
BeFore eacH uSe,
1.
general condition of the Metal Detec-
tor. Check for loose screws, miss-
ing parts, cracked or broken parts,
damaged electrical wiring, and/or
any other condition that may affect its
safe operation.
2.
aFter uSe,
of the Metal Detector with soft, clean
cloth.
to preVent
SeriouS injury:
inspect the
clean external surfaces
Page 7
Advertisement
Table of Contents
