Table of Contents
Advertisement
SpeciFicationS
Housing, Support Arm, Meter
Construction
Housing and Search Coil: PVC
Materials
Thermoplastic.
Stem: 2-Piece Aluminum Shaft.
1/8" Diameter Jack. Earphones
Earphone Port
not supplied.
Adjustable
31" Minimum, 43" Maximum
Length
(Overall).
6-AA Batteries 1.5V (Not
Power Source
Supplied).
Search Coil
180°
Adjustment
unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Set up inStructionS
read the entire important
SaFety inStructionS
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
operation:
turn the power Switch of the
metal detector to its "oFF"
before making any
adjustments.
aSSemBly
note: There is NO assembly required for
this Metal Detector.
SKU 98760
to preVent
accidental
For technical questions, please call 1-800-444-3353.
operating inStructionS
read the entire important
SaFety inFormation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
1.
Before operating the Metal Detector,
put on ANSI-approved safety goggles
and other safety gear. Safety gog-
gles and other safety gear are sold
separately.
2.
Turn off the Volume Control.
Figure 1
3.
Install batteries (not supplied). The
Battery Compartment (36) is located
on the underside of the Control
Housing (9,17). Remove the Battery
Cover (37). Insert 6-AA batteries be-
ing careful to follow the Plus (+), and
minus (-) polarity markings inside the
Battery Compartment (36). Replace
the Battery Compartment Cover (37).
See Figure 1, above.
Battery
Compartment
Cover (37)
Battery Com-
partment (36)
Page 4
Advertisement
Table of Contents
