Fujitsu SPARC Enterprise T2000 Product Notes page 22

Specific Issues and Workarounds (Continued)
TABLE 1
CR ID Description
6341045 If a CPU or memory fault occurs while the server is
running a trap handler, the system might panic with
a bad trap instead of providing a CPU or memory
fault message. In such cases, memory scrubbing is
not performed.
6338962 The system might hang after a panic when the sync
command is used.
6338365 Sun Net Connect 3.2.2 software does not monitor
environmental alarms on the SPARC Enterprise
T2000 server.
6336040 After a failed DIMM was cleared from the asr
database, ALOM CMT might not properly reboot and
returns the following error message:
No valid MEMORY configuration
6325271 The console history boot and run logs are the same.
6318208 Whenever the system resets, including after a POST
reset, you might see the following message: Host
system has shut down
6317382 Typing unrecognized commands or words at the ok
prompt causes the system to return the following
erroneous error:
ERROR: Last Trap
and might hang the server.
6315238 Recycling AC power results in the following
erroneous message:
Preceding SC reset due to watchdog
6314590 Executing the ALOM CMT break and go commands
might cause the system to hang.
6312364 When accessing the host through the ALOM CMT
console command, you might experience slow
console response.
14 SPARC Enterprise T2000 Server Product Notes • September 2011
Workaround
Reset the server, and check the server for
possible faults using the showfaults
command.
If the server hangs, reset the server from the
system console.
To receive notification that an environmental
error has occurred, use the ALOM CMT
mgt_mailalert feature to have ALOM CMT
send an email when an event occurs.
To check whether or not the environmental
status of the server is ok, log on to ALOM CMT
and run the showfaults command.
To view a history of any events the server
encountered, log on to ALOM CMT and run the
showlogs command.
Wait 10 seconds after executing the clearasrdb
command before executing the resetsc
command. Refer to the SPARC Enterprise T2000
Server Service Manual for information about
clearing DIMM-related faults.
At this time, no workaround is available for this
issue.
Disregard this message. The system will be reset
and display the OBP ok prompt as expected.
Disregard this erroneous error message. If the
server hangs, reset the server from the system
console.
Disregard this message.
If the console hangs, reset the system.
For optimum responsiveness, access the host
through the host network interfaces as soon as
the host has completed booting the Solaris OS.