Installation / Wire Connection Guide; Before Starting; Package Contents; General Cautions - Clarion CZ102 Owner's Manual

9. INSTALLATION / WIRE
CONNECTION GUIDE
CONTENTS
1) Before Starting ................................................................................. 10
2) Package Contents ............................................................................ 10
3) General Cautions ............................................................................. 10
4) Cautions on Installation .................................................................... 10
5) Installing the Source Unit ................................................................. 10
6) Removing the Source Unit ............................................................... 11
7) Wiring and Connections ................................................................... 12
8) Connecting the Accessories ............................................................. 12

1) Before Starting

1. This set is exclusively for use in cars with
a negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery
"terminal" before starting. This is to
prevent short circuits during installation.
(Figure 1)

2) Package Contents

Source unit .................................................. 1
Front panel .................................................. 1
Trim ring ...................................................... 1
Mounting bracket ......................................... 1
Screws M5x6 mm ........................................ 4
L-key ............................................................ 2

3) General Cautions

1. Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
Car battery
Figure 1
Wire connector ............................................ 1
Remote control unit (with battery)................ 1
Owner's manual........................................... 1
Warranty card .............................................. 1
Special screw (Front panel lock) ................. 1
2. Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner, benzine,
or alcohol etc. For tough dirt, apply a little
cold or warm water to a soft cloth and wipe
off the dirt gently.

4) Cautions on Installation

1. Prepare all articles necessary for installing
the source unit before starting.
2. Install the unit within 30° of the
horizontal plane. (Figure 2)
3. If you have to do any work on the car
body, such as drilling holes, consult your
car dealer beforehand.
Max 30˚
Figure 2

5) Installing the Source Unit

1. Place the mounting bracket into the instrument panel, use a screwdriver to bend each stopper
of the mounting bracket inward, then secure the stopper.
2. Wire as shown in Section 7) .
3. Insert the source unit into the mounting bracket until it locks.
4. Take care of the top and bottom of the trim ring and mount it so that all the hooks are locked.
Notes:
1. Some car models require special mounting kits for proper installation.
Consult your Clarion dealer for details.
2. Fasten the front stopper securely to prevent the source unit from coming loose.
• Console opening dimensions
7-3/16"
(182 mm)
Hole
4. Use the enclosed screws for installation.
Using other screws can cause damage.
(Figure 3)
Chassis Chassis
Damage
Max. 6 mm (M5 screw)
Figure 3
10